SKU: RCD-202400-0004-460-MP
RCD BB FORD Crankshaft Support w MOTORPLATE Extended Crankshaft Support, Complete w Mandrel No Hub

Crank Support for BB 429-460  FORD when Using a Motorplate   EXTENDED to accommodate a 1V Accessory Pulley  if desired *

This is a BB Chevy unit That uses a Ford RCD HUB  - *   optional

 You will have to Drill your MotorPlace to position This support 

Included is the Steel Mandrel w 1"  nose shaft on it to drive Fuel Pump or  Dry Sump     

Shown with optional Fuel Pump Drive Bracket and  Accessory Mandrel  

Option for RCD Blower Hub if you don't have a Hub- Won't work w a Balancer 

RCD's Big Block FORD  Extended Crank Support

Allows for a 1V Accessory pulley -

5-1/4"  From back of the bearing  to the back of the support touching the  motorplate 

Comes with the RCD long BB FORD  hub and the Wheatland Mandrel w  1" Accessory Drive Provision 

See RCD 7" Crank Trigger Wheel to use with RCD Blower Hub

Bearing rated to over 9000  RPM 

Measurements   6"  inside Front to Back     7" Outside Front to Back

9-1/2"   Across inside to where the Motor Plate Bolts will go      Outside to Outside  14-1/2"   

Shown w RCD  Accessory Drive Shaft - optional  

The Support is   6”  inside front to back      7”  to the outside  from the front to the very back

9-1/2”  inside  the Motor Plate Mounts  top  and 9”     on the bottom

Outside total width   14-1/2”    

We would use a BB Ford  Blower Hub and a mandrel that has 6 bolt 

holes and  interlocks ( Registers )  inside the Blower Pulley 2”  Register .  

Can have a 1” Dia shaft sticking out to drive various  things like Fuel Pump or oil pump  or whatever you like  . 

 Since no good company makes the BB Ford  we use the BB Chevy since it  does not know  where it is sitting-