SKU: EN-BAU3-438BA
Enderle BAU3 Big and Ugly w 4-3/8" butterflies Blown Alcohol - Alkydigger

  BAU3   4-3/8"  Blown Alcohol - 
 4- 3/8"  Butterflys    45 sq inches of air surface-  good for most engines up to 550  cu in 

New  Enderle the Big and Ugly  BAU-3

This is a 3-hole type that looks like the Top Fuel injectors.

This has 4-3/8" butterflies which makes it great for  smaller to med  cubic inch engines from  400  to  -550 with moderate boost  ,   and is approximately 8.75" tall.  *  guideline only

Comes setup with:

• barrel valve - K Valve Cast or Billet  your choice 
  
• SS fuel lines and 2 rubber hoses
• nozzles and bodies
• idle and check valves
• distribution block
• bypass jets 
  
• Tuned for your application  
  

 Width Outside  of linkage = 18"

Width Outside of  housing  14"

 and is approximately 8.75" tall.
See our "Partial" version for EFI conversion.

Our Casting Disclaimer:

 Enderle Scoops and Hat Injections are made from older casting molds that are original molds and are cast in very limited quantities.

There are casting flaws that have been there from the beginning and will always be there.   We cannot do anything about this and the manufacturers will not.   

 In addition, as time has gone on, many foundries have closed, leaving the castings to be done by very small Mom and Pop foundries.  It is most common to see pits and small imperfections which either will not buff out or would cause too much damage to the casting to try to buff it out. 

We do not give refunds, allowances, re-buffing jobs, or swap outs for other injectors.