Enderle Blown Alcohol Bugcatcher Injector - Smooth Top - up to 1300 HP with approx. 18 lbs boost - approx.
Fits all 6-71 8-71 10-71 14-71 with standard top
3 11/16" Butterflies
Complete - Blown alcohol
Stainless lines
Jets
Nozzles
Barrel Valve
Secondary valve
Mounting gasket
Fuel pump 7.00 gpm * Enderle, or Waterman 80A or 700 Sprint
-8AN Shut off Valve w Cable and bracket
-12 AN 100 micron fuel filter- permanent stainless
Timing cover - SB Chev , BB Chev, SB Ford, ( when available ) OR
Belt Drive that drives from the bottom blower pulley 6 bolt only with a motorplate
Instructions
Butterfly colors- Blue-Red-Black - Polished ( Brass only with offshort Bugcatcher )
All you should need is hoses to plumb it
Setup and flowed for your engine
Our Casting Disclaimer:
Hilborn and Enderle Scoops and Hat Injections are made from older casting molds that are original molds and are cast in very limited quantities.
There are casting flaws that have been there from the beginning and will always be there. We cannot do anything about this and the manufacturers will not.
In addition, as time has gone on, many foundries have closed, leaving the castings to be done by very small Mom and Pop foundries. It is most common to see pits and small imperfections which either will not buff out or would cause too much damage to the casting to try to buff it out.
We do not give refunds, allowances, re-buffing jobs, or swap outs for other injectors.
Bugcatcher kit , Bug Catcher