1002 OR 1002F Enderle Blown Alcohol Bugcatcher Injector - SMOOTH TOP OR FINNED TOP - up to 1800 HP or with over 20 lbs boost - "High Boost" Complete Setup

Fits all 6-71 8-71 10-71 14-71 250's & Can fit a 192 Blower

Comes with a 9 gpm to 13.4 gpm Waterman pump with option to go to a 14- 15-16 gpm Lil Bertha

3 11/16" Butterflies

Complete - Blown alcohol

Stainless lines- Rubber port lines * We prefer rubber hat lines for less vibration

Jets -Nozzles

COMES W 16 INJECTORS FOR HAT & PORTS

K Valve Barrel Valve * Cast with a Billet Option

Secondary valve

high speed Lean out Valve

Mounting gasket

FUEL PUMP 10 gpm to 13.4 gpm * or Waterman Super Sprint ( Mini Bertha) WORLDS FINEST SPUR GEAR

Port Nozzles kit with 8 additional Injectors

-8AN Shut off Valve w Cable and bracket

-8 AN 60 micron fuel filter- permanent stainless for Pressure side .

-16 filter cone 70 micron Inlet Side

Timing cover - SB Chev , BB Chev, or SB Ford- BB Ford- OR

Belt Drive that drives from the bottom blower pulley 6 bolt only

Belt or Timing cover drive

Instructions

Butterfly colors- Blue-Red-Black - PURPLE - POLISHED

All you should need is hoses to plumb it

Setup and flowed for your engine

Our Casting Disclaimer:

Enderle Scoops and Hat Injections are made from older casting

molds that are original molds and are cast in very limited quantities.

There are casting flaws that have been there from the beginning and will always be there.

We cannot do anything about this and the manufacturers will not.

In addition, as time has gone on, many foundries have closed, leaving the castings to be done by very small Mom and Pop foundries.

It is most common to see pits and small imperfections which either will not buff out or would cause too much damage to the casting to try to buff it out.

We do not give refunds, allowances, re-buffing jobs, or swap outs for other injectors.

Bugcatcher kit , Bug Catcher