SKU: EN-1001setup
Enderle Bugcatcher Blown GAS or E-85 Complete Setup Smooth Top Enderle , 3-11/16"

Enderle Blown GAS and E-85  Bugcatcher Injector - Smooth Top  -

Fits all 6-71 8-71 10-71 14-71 with standard top 

3 11/16"  Butterflies
Complete - Blown GAS and E-85
Stainless lines
Jets
Nozzles
Barrel Valve
Secondary valve

Mounting gasket

Fuel pump New Enderle or Aeromotive  

-6AN Shut off Valve w Cable and bracket

-10 AN 60 micron fuel filter- permanent stainless

Timing cover - SB Chev , BB Chev, SB Ford,   OR 

Belt Drive that drives from the bottom blower pulley 6 bolt only

Belt or timing cover drive

Instructions

Butterfly colors-  Blue-Red-Black 
 

All you should need is hoses to plumb it

Setup and flowed for your engine

Recommend our surge tank for street use 

Our Casting Disclaimer:

Hilborn and Enderle Scoops and Hat Injections are made from older casting molds that are original molds and are cast in very limited quantities.

There are casting flaws that have been there from the beginning and will always be there.   We cannot do anything about this and the manufacturers will not.   

 In addition, as time has gone on, many foundries have closed, leaving the castings to be done by very small Mom and Pop foundries.  It is most common to see pits and small imperfections which either will not buff out or would cause too much damage to the casting to try to buff it out. 

We do not give refunds, allowances, re-buffing jobs, or swap outs for other injectors.