New Product Lines- Moroso & Engler Fuel Injection coming Soon- HILBORN Parts in Stock-The Blower Shop's Largest Dealer-RCD Engineering -APD Carbs largest Stocking Dealer
Product Search

    Secure Checkout
    Enderle Big & Ugly  BAU3-EFI   4-3/8"   on  Alkydigger  SB Chev  Tunnel Ram

    Thumbnail Filmstrip of Enderle Big & Ugly BAU3-EFI 4-3/8" on Alkydigger SB Chev Tunnel Ram Images

      Purchase Enderle Big & Ugly BAU3-EFI 4-3/8" on Alkydigger SB Chev Tunnel Ram

      SKU: AD-7070-BAU3-EFI
      Enderle Big & Ugly BAU3-EFI 4-3/8" on Alkydigger SB Chev Tunnel Ram

      $7,975.00

       
       
       
       
       



      Use for  383-400-406-410-421-434-  and up  engines on methanol or E-85  Supports up to 1200  hp on GAS  
       
      Enderle   4-3/8" Big and Ugly on a Tunnel Ram for methanol
      ( Same square inches of butterfly as a Birdcatcher ) 
      you can have our BAU4 Upright for  $300 Less 

      SB Chevy - 23 degree * We also offer a 18 degree  special order ( We have to send your heads in to be  fitted ) 

      Alkydigger Custom Tunnel Ram AD-7070  
      Will have Progressive Linkage  one B Fly opens first then two follow  
      Fuel Rails  mounted on Manifold  
      8- EFI injectors from 55 lbs to 83 Depending on HP  Desired
      Holley Terminator EFI System
      Aeromotive Fuel Pump-Regulator-
      Dual Fuel Filters 
      Wiring Harnesses  
      TPS  Switch 
      Will take about 3 weeks to get the Fuel Rails  accomplished 
      should Run Great on the Street  


        BAU Is approximately 8.75" tall.

       Width Outside  of linkage = 18"

      Width Outside of  housing  14"

       Manifold   and is approximately 8.75" tall.Overall is  18" 

      For 360 or Smaller engines we Recommend the Bugcatcher or the 3-11/16" BAU3    .

      Call us for the 3-11/16"   615-457-3192

       

      Our Casting Disclaimer:

      Enderle Scoops and Hat Injections and Alkydigger tunnel Rams   are made from older casting molds that are original molds and are cast in very limited quantities.

      There are casting flaws that have been there from the beginning and will always be there.   We cannot do anything about this and the manufacturers will not.   

       In addition, as time has gone on, many foundries have closed, leaving the castings to be done by very small Mom and Pop foundries.  It is most common to see pits and small imperfections which either will not buff out or would cause too much damage to the casting to try to buff it out. 

      We do not give refunds, allowances, re-buffing jobs, or swap outs for other injectors.

       



      Related Products