Chevy 250 Billet 16 Rib Serpentine LS LS3 L92 REC port Blower Package - The Blower Shop 250 Complete with Manifold and Drive

LS 3 and L92   Chevy- 250 Blower Setup  -  Complete Kit

Fits under hood  usually with no modifications - overall height of manifold, blower and carb adapter is 10.56"

A Carb or Bugcatcher will add about 5"  height 

the top on this blower is same as a 8-71  or 6-71  pattern-  whatever fits them, fits this as well  .

Solid Billet , with Billet 2 lobe rotors.    Mirror like polishing. 

makes PLENTY of boost for any engine up to 500 cu in -  for Street or Marine use

Great Street sleeper blower to hide under the hood.  

HLY550-531  is a great efi   setup 

Street engines on pump gas will have to have 9-1 compression or  less or use our Torco Octane booster to raise 93 octane to 103

Also Used in High Compression  12-1   13-1  LS   Chevy Race cars to add 3-4 lbs of boost to equalize Atmospheric

conditions when the air gets dirty, and/or  corrected elevation  and density altitude caused a negative impact on  your ET .

A 71 style Supercharger sticking out of the hood is always a nice addition, but it may not be what you are looking for.  With our 250 BilletCharger blower series we have solved that problem. Still producing the most boost in the industry these dangerously powerful blowers come in a beautifully small package.  Perfect for tight clearances and low profile under-the-hood applications. 

BILLET ROTORS ARE HARD ANODIZED AND COME WITH 6 POINT TEFLON STRIPPING

BILLET CASES ARE HARD ANODIZED INTERNALLY

Specs:

• Billet Case
  • CNC machined 6061-T6 Aluminum
  • Increased Strength over cast
  • Hard Anodized Interior
  • Mirror-Like Polish
  • Low Profile Design (6.56” tall including Billet Carb Adaptor)
  • Single or Dual Carb (4150 or 4500 *Please Specify when Ordering) 
• 2 Lobe Rotors
  • Billet Extrusion
  • Teflon OD Stripping
  • Full length rotor shaft for increased strength
  • Maximum boost at low RPM 
• Billet Front Cover
  • Oil Level Sight Glass
  • Oil Drain Plug
  • Polished Pressure Relief Valve 
• Billet Bearing Plates
  • Increased Strength over cast
  • Hard Anodized
• Included:
  • 250 Billet Supercharger with Snout
  • Intake Manifold
  • Accessory Pulley 2V belt or Serpentine
  • Supercharger Pulleys (*Please specify engine size and desired boost when ordering)
  • Belt 2"  16 Rib Serpentine  Belt 
  • Idler Assembly (Spring Tensioner, Pulley)
  • All Necessary Gaskets and Hardware
  • you will need a Aftermarket Balancer  Innovators West or ATI   
  • We stock the  ATI - Innovators West  or RCD  Blower hub. 
  • Dual EFI Throttle Body Injection system  from Holley  works well  
  •