CLIENT LOGIN | ORDER STATUS | TRACKING
NEW - ENDERLE 2 -3/16 " Injector unit for SB Chevy with regular 23 degree heads.
This setup is NEW , Will support 850 HP with 383 cu in on Alky
This 2 -3/16" will serve a 305-383 cu in WELL.
Canted Stacks can be staggered in length
Can work great for larger than 383 engines that are not turning over 8000 rpm consistantly-
If so, you should consider our NEW Hilborn 2-7/16" " Stack unit . Or Hilborn Mega Power
Comes with :
Idle check Valve-Secondary Valve-Jet selection for your setup-Flowed for your engine
8" Aluminum Ram tubes Shown- Ram Tubes will polish like chrome if you choose to.
(See last 2 pictures for polished stack shots)
We also now have 14" Stacks for a total height of 18"
Add support parts : Pump, Drive, shut off, Filter, jets, drop down option
Nozzles ARE included- Alky or Gas or E-85
Use a 1205 FelPro Gasket
These products are recommended with this item
Factory Replacement Throttle Shafts
5/16" or 3/8" diameter-
Tell us your casting # on bottom of injector casting
For Hilborn or Enderle, and some Kinsler Shut off Valves .... 10' - can be easily cut to length
Fuel Pump Primer Kit - Start Every Time- CANNOT be put in an area where vacuum occurs - it will become sucked open .
no pit crew needed
Timing Cover for SB Chevy - 265-283-327-302-350-400
Comes with Seal # 17678
add optional Spud or Polishing
SKF Oil Seal for Enderle Timing Cover SB Chevy Std Crank
.055 through .150 in nice pill holder
Crankshaft Mandrel SBC/BBC
SB - BB Chevy Cam Drive Spud- for use in Hilborn Timing covers - This spud will work in all timing covers, but the Enderle Spuds will not work in a Hilborn cover due to the Hilborn cover having a roller bearing.
Will NOT fit 1990 and up SB and LS due to different pattern - see our 5005.LS for small bolt circle spud
Pump mounting bracket with 5/8" Pulley Shaft, bearings, ready for your pulley
Bracket with a 28 or 32 Tooth Pulley Choose from the Drop Down -Drives 3 or 4 bolt
Belt Drive for Small Block Chevy Engines to drive the fuel pump off to the side of the engine.
2-1/16" x 1-1/4"
NEW 4 Way Shut Off Valve #6 - Special application
Can use this with a Hilborn-Crower-Kinsler- and install a by pass valve on the port that is always open.
These are our current best sellers.
NEW Hilborn Jets (Pills) Sizes .030 - .210----- Precision laser Drilled
Screen Gasket for GMC Type Blower
6-71, 8-71, 10-71, 14-71
Gasket for GMC Type Blower
6-71, 8-71, 10-71, 14-71
3rd picture shows a selection we sell 7009.asst
for Port Nozzles and All Unblown engines use - 7007-PI
8AN Body This is a -8AN Shut off comes standard with -8 bulkhead fitting, we can put a flare fitting in it if you want .....just let us know how you want it
10 AM - 5 PM M-F CST
Sales & Orders: Toni, Shannon, Mike
Tech Questions returned when time permits