SKU: EN-1003
Birdcatcher Blown Gas or E-85 - Enderle

   1003   Enderle Polished  blown gas Birdcatcher injector is complete with:

• barrel valve  Square * optional K Valve available 
• fuel lines- Stainless or Rubber , your choice
• nozzles & bodies
• check valve
• distribution block
• bypass pills
• Secondary Valve for idle control
• Marginal for street use- Weekend Warrior only
• Should be 475 cu in or greater, for less cu in engines on GAS, use a Bugcatcher for better performance.

Our Casting Disclaimer:

  Enderle Scoops and Hat Injections are made from older casting molds that are original molds and are cast in very limited quantities.

There are casting flaws that have been there from the beginning and will always be there.   We cannot do anything about this and the manufacturers will not.   

 In addition, as time has gone on, many foundries have closed, leaving the castings to be done by very small Mom and Pop foundries.  It is most common to see pits and small imperfections which either will not buff out or would cause too much damage to the casting to try to buff it out. 

We do not give refunds, allowances, re-buffing jobs, or swap outs for other injectors.